NewChallengerStore.com
Included: 1
x Door
Control Trim Plate, 1 x packet of promoter 1. IMPORTANT NOTE: BEFORE YOU BEGIN YOU MUST FIRST PREP THE SURFACE IN ORDER TO ALLOW ADHESION. You do this by scrubbing the entire area with household Isopropyl Alcohol (or rubbing alcohol) found at most grocery stores and all hardware stores. Scrub the are vigorously to remove any hint of oil. . 2. Once properly cleaned take the piece of test strip tape (included) and remove a portion of the back red liner. Stick the test tape strip to the area in your interior where you will be mounting your new trim. Test several areas. If it is tacky and sticks then proceed to the next step. If it is not sticking very well in any of the spots you tested then re-clean the area until the test strip sticks to all areas. If the test strip tape doesn't stick well neither will your new trim piece.
3. Now that your interior
areas have been prepared use the adhesive promoter packs/tubes
(provided) to wipe the areas of your dash or door where your new
stainless pieces will be mounted. Allow a few seconds to dry.
You have been provided with attachment
tape test strips. Use one of these to test the tack. If it seams to
stick well then you can proceed with your installation. If you can
not get the test tape to stick you will need to re-clean/scrub with
the 'Isopropyl' cleaner.
|
|