NewChallengerStore
Included:
2 x
Stainless Inserts,
1 x Adhesive Promoter Pack
This new and unique bumper insert has been designed to fit into the recess of the factory bumper adding a custom look to what would otherwise be a plain looking rear end. Your new inserts come to you with a protective liner. Do not remove liner until installation is complete. 1. Thoroughly scrub clean the bumper insert area with household Isopropyl Alcohol (or rubbing alcohol) found stores hardware department to remove any and all waxes and oil. 2. Once properly cleaned take the piece of test strip tape (included) and remove a portion of the back red liner or a piece of masking tape . Stick the test tape strip to the area in where you will be mounting your new trim. Test several areas. If it is tacky and sticks then proceed to the next step. If it is not sticking very well in any of the spots you tested then re-clean the area until the test strip sticks to all areas. If the test strip tape doesn't stick well neither will your new trim piece.
3.
Take the
promoter (included) and swipe the entire area where your trim will
stick to. This will insure a nice strong bond long term. The
promoter is clear and will not damage or stain your paint or
interior.
|